sorry, no pics (yet).
However, there are a few difficulties.
First off, the standoffs. None of them match. So they're all in the way.
I would like to reuse them; however, they were special-riveted on. So they're headed into the bin.
Another problem: With the positioning of most boards, the RAM and optical drive are in the same area.
So I am either going to get a slimline drive or one that doesn't go so deep.
Third thing: There is a plastic part that helps in the case staying shut. However, it flowed around the standoffs. I would have to either carve around it or leave it out altogether.
I'll try to get pics (of this) as soon as I can.
However, I have
I have taken the old standoffs off.They are about the same height of a regular standoff, so I need to find some.
I have taken the G3 stickers off of one side. Why? They're going onto another case.
I also found out that the mounting points are the same with the PSU.
So I have a PSU in. 250W, 17A 12V rail, I think.
I'm gonna get my new hardware. And my worklog here.