ASUS P5VD2-VM SE BIOS ROM checksum error

Moderator: The Mod Squad

ASUS P5VD2-VM SE BIOS ROM checksum error

Postby rascard2007 » Mon Sep 30, 2013 11:21 am

Hi friends, quite a long time out of the forums!!

yesterday a friend came to my house with his PC that wasn´t working from few days ago.

I turn on te computer and in the first run I got the message

CMOS checksum error
press f1 to enter setup
press f2 to load default.........

I entered in setup put the rigth date and time and then F10 and yes

after the reboot the pc enter windows normally but after a couple of minutes the PC restarted and i got the message:

BIOS ROM checksum error
Detecting floppy drive A media ...
INSERT SYSTEM DISK AND PRESS ENTER

I turned of the computer wait about ten minutes and then the PC starts fine again but after entering windows the pc resets and I got the same BIOS ROM checksum error again!

What can be the issue?
- CMOS battery?
- BIOS failing?
- Bad BIOS chip?
- Bad Caps?

or anything else.... Help me please
"I have only come here seeking knowledge,
Things they would not teach me of in college"
-Wrapped Around Your Fingers-
-The Police-
rascard2007
Black Belt
Black Belt
 
Posts: 720
Joined: Tue Jun 12, 2007 10:47 am
Location: Havana, Cuba

Postby Toby B. » Mon Sep 30, 2013 12:09 pm

you can refer to www.badcaps.net for more info on what to look for. bulging, leaking, domed caps.. Depending on make and model of PSU, that could probably use a look as well.

As far as the BIOS battery, if it's more then a couple years old it's a good idea to go ahead and replace it. If you have a multimeter, you could check the voltage, but I am not certain on what the zone is for what is good.

If the BIOS program was failing I would expect some other form of issue.. like a pixilated boot screen. Not to say that is not the problem, been doing more code stuff versus hardware. If the chip was failing I would expect, similar problems.
Toby B.
Lead Mobo-fu Master
Lead Mobo-fu Master
 
Posts: 14277
Joined: Sun Dec 16, 2001 1:01 am
Location: Maine

Postby Roach412 » Mon Sep 30, 2013 12:34 pm

my money would be on battery.

-Roach
Lian Li Lancool First Knight Series PC-K59W
Intel Core i7-960 Bloomfield 3.2GHz
EVGA X58 FTW3 132-GT-E768-TR
EVGA GeForce GTX 1070 FTW GAMING ACX 3.0
G.SKILL Ripjaws Series 12GB (3 x 4GB)
Crucial M4 128gb SATAIII SSD x2
Crucial M4 256gb SATAIII SSD
OCZ Saber 1000 960GB Enterprise SSD
Corsair Professional Series HX850 PSU
Dell UltraSharp U2713HM 27" w/drop ceiling mount
Logitech G930 7.1 Headset
DBPOWER RGB LED Keyboard
Logitech G402 Hyperion Fury
Roach412
Black Belt 2nd Degree
Black Belt 2nd Degree
 
Posts: 2718
Joined: Mon Aug 09, 2004 7:33 pm
Location: Milwaukee - Wisconsin

Postby Karlsweldt » Tue Oct 01, 2013 7:18 am

Test the BIOS battery in circuit. First, remove the AC mains cord. Attempt a few starts to drain the PSU reserve. Then with a digital multimeter, the top of the cell is marked positive (+) and any bare chassis point or black lead terminal is negative (-). A good battery should show 3 volts. Any lower than 2.8 volts is critical and may cause BIOS settings to default.
That "checksum error" message covers up to 20 critical features.
The BIOS battery is only a redundant feature to retain BIOS settings in the CMOS memory when no power enters the PSU. Even if the PSU is not active, the +5 volt stand-by voltage powers the BIOS and USB circuits.
Depending on draw, the battery may last two years average.
F@H.. to solve mankind's maladies.. in our lifetimes!
Karlsweldt
Mobo-fu Master
Mobo-fu Master
 
Posts: 20687
Joined: Wed Nov 12, 2003 11:57 am
Location: 07438

Postby rascard2007 » Tue Oct 01, 2013 12:16 pm

well I tried last nigth a new battery (I had it in its package from a few months ago) and everything went the same, first boot the BIOS checksum error, insert the flpppy message

after that any time I turn the pc on It stucks on reading the Floppy disk drive and checking the DVD drive, but no video and no beeps at all.

Is it trying to start some automatic recovery??

I put the original CD on the DVD drive and nothing happens
"I have only come here seeking knowledge,
Things they would not teach me of in college"
-Wrapped Around Your Fingers-
-The Police-
rascard2007
Black Belt
Black Belt
 
Posts: 720
Joined: Tue Jun 12, 2007 10:47 am
Location: Havana, Cuba

Postby evasive » Tue Oct 01, 2013 10:57 pm

Did you check the badcaps website?
We hate rut, but we fear change.
********************************
System error, strike any user to continue...
evasive
Mobo-fu Master
Mobo-fu Master
 
Posts: 37389
Joined: Sun May 06, 2001 12:01 am
Location: Netherlands

Postby Karlsweldt » Wed Oct 02, 2013 7:15 am

When you get that 'checksum' error message, go into the BIOS to check the date and time plus other settings. If the date and time wander off greatly, suspect a circuit fault that does not provide proper voltage to the BIOS circuit. Measure the +5 volt stand-by voltage at the main power socket.. the violet wire.. to ground. Should be right at +5 volts or maybe +5.3 volts max. A one-way diode from that feed powers the BIOS circuit. Another one-way diode from the battery is a backup. Gold contacts don't corrode or oxidize.. but almost every other metal will. Possible also there is a cold-solder connection that has now reared its menacing head, after many months or years of use. Any solder joint that appears "dull" at the surface can be suspect. But use heat sinks with any sensitive components, if attempting to touch-up any suspect solder joints!
But as evasive noted, inspect all large capacitors for bulging tops, excess leaning, or signs of leakage. The PSU also should be examined!
F@H.. to solve mankind's maladies.. in our lifetimes!
Karlsweldt
Mobo-fu Master
Mobo-fu Master
 
Posts: 20687
Joined: Wed Nov 12, 2003 11:57 am
Location: 07438


Return to BIOS

Who is online

Users browsing this forum: Lindex [Bot] and 1 guest