voltage mods

[aussiejunior]

Howdy again. Does anyone know how to do a few voltage mods on an asus a8n sli premium mobo or an nvidia 7600 gt?
My mobo only goes to 1.55v and I think thats holdong back my overclocking lol.. at 1.55v I can get my 3200+ up to 2.808 ghz stable with settings of
312 fsb and a cpu multi of 9 with temps no higher then 58c full load on prime 95
My vid card however doesn't overclock much at all.
I can get the core up to 645mhz and the mem to 1510 mhz
a jump from 590 core and 1480 mem.
All this is done with air cooling lol... Not to shabby i reckon lol

[MrMozart]

You might try a different ram divider. You get best results if the ram and fsb
run 1:1. I have found that the 266 divider works out pretty good. Of course you need decent ram. I am not familiar with the ram in your sig.

[aussiejunior]

I'm already using a ram divder set at ddr266 to get my cpu to 2.808ghz.. the ram is only running at stock speeds of ddr 400 to hit that speed so I dont think thats the problem.. I need more voltage to go any higher I think

[MrMozart]

You might boost your ram voltage to 2.7v. Also you should change your memory timing from 2T to 1T if you haven't already.

[aussiejunior]

I've tried raising mem voltage up to 3v at small increments and nothing works... mebbe I've just hit an air cooled ceiling on the cpu lol.. but I spose 2.8ghz is as good as it gets from a 3200 lol

[MrMozart]

You probably have maxed out on this board. 3v on your memory is too much. If you left it there you would probably fry it.