The Mother Board

[Ben77]

My question is the same as Worleybird who posted earlier, but my specs are a little different. Also, I'm using the cpu fan that came with my cpu, any suggestions? Please Help!

P4 1.8 ghz
Antek servercase 330watts- 4 case fans
MSI Geforce4 ti 4400
Raid 0 : two 80 gig 7200rpm hard drives
Samsung 512mb DDR 7200rpm ram

Where should I start with on the following:
CPU:DRAM ratio
CPU clock (FSB)
CPU Clock ratio (Auto or 8x to 50x)
Autodetect DIMM/PCI Clock (disabled or enabled)
Spread Spectrum (disabled or enabled)
CPU Vcore
DDR Vcore
AGP Voltage select

What should I do with the advanced Turn up settings?
CAS latency
RAS active time
RAS precharge time
RAS to CAS delay
ACT to ACT delay
Write Recovery time
R/W turn around time
Read Latency control
Time constraint control
GW Write Mask AGP Request
AGP Fast Write Capability
Refresh Cycle time
DRAM Addr/cmd rate

What about?
CPU L2 Cache ECC checking
Prefetch Caching
AGP Aperture size

[Aibohphobia]

You can find much on RAM info here: http://www.pcguide.com/ref/ram/timing.htm

And http://www.itcp.net/~awsh/Speed_Demonz/BIOS_Guide/BIOS_Guide_Index.htm for almost everything else.
_________________
Go hang a salami; I'm a lasagna hog!
A man, a plan, a butt tub: anal Panama!
Goddam mad dog!