Page 5 of 8

PostPosted: Sun Jul 18, 2004 7:53 am
by ether.real

PostPosted: Tue Aug 03, 2004 3:56 pm
by video
http://www.48bitlba.com/



hardrive install

DRIVE IMAGING SOFTWARE

PostPosted: Mon Aug 16, 2004 7:27 pm
by bruhthaKuga
Digital Dolly is a freeware drive imaging utility for home users. It works fine you will just have to read the manual carefully. You will have to make a FAT32 partition to save an image of a NTFS system partition. Don't forget to mount the partition or drive that you want to save to.

http://www.innotrix.com/digital_dolly/download.htm

PostPosted: Mon Sep 20, 2004 8:17 pm
by Mac4970
Prime95 - http://www.majorgeeks.com/Prime95_d4363.html

"This program is a good stress test for the CPU, memory, L1 and L2 caches, CPU cooling, and case cooling. The torture test runs continuously, comparing your computer's results to results that are known to be correct. Any mismatch and you've got a problem! Note that the torture test sometimes reads from and writes to disk but cannot be considered a stress test for hard drives".

Prime 95 Torture test - an excellent little program for cpu thermal and/or stabilty testing in overclocked or normal system setups.

Toggling Screen Saver

PostPosted: Wed Sep 22, 2004 7:33 am
by trexntx
Ran across an article in PC World today where it gives a method whereby you can toggle your screen saver with a single click.

Useful for preventing the screensaver from interfering with burning, degragging or other activities without the difficulty of navigating to the dialog box to do it within display properties.

Not sure where it would be best to post this, so if somebody thinks it ought to be moved then by all means go right ahead.

http://www.pcworld.com/howto/article/0, ... 423,00.asp

PostPosted: Thu Sep 23, 2004 6:49 am
by Hardware Junkie

PostPosted: Sat Oct 09, 2004 4:37 pm
by Ryn

PostPosted: Sat Oct 16, 2004 7:10 am
by Aussie
Startup Library list:-

http://startup.iamnotageek.com/



Aussie

Re: System Fan GA7ZX

PostPosted: Wed Oct 27, 2004 9:43 pm
by Sabrewings

PostPosted: Thu Oct 28, 2004 5:58 am
by Karlsweldt
Lots of good suggestions for "software" tools, but no "hardware" tools.
If I may add, the "good" computer toolbox should not be without a few different types of Hemostats, for picking up those dropped parts in tight places, or removing/installing the jumper caps on pinset headers. Also a decent-sized pair of end-nipper pliers, to cut protruding wire ends from circuit boards. Work well at squeezing the "arms" on plastic standoffs for removal. Crutchfield's catalog is one source.. there are many others, including medical supply houses, for the Hemostats. The pliers and other tools are available at most hardware stores. A pair of "chip poppers" similar to the ones made for removing the older '486' CPUs will be of assistance in removing any CPU from its socket, if you have no fingernails to get under the chip. Gently, of course!