Issue with AST Premmia MX P/60 giving 11.01 message at post.

Moderator: The Mod Squad

Issue with AST Premmia MX P/60 giving 11.01 message at post.

Postby dani9678 » Sun Dec 10, 2017 1:29 pm

When powering on I get the following message: 11.01 System encountered a hardware problem and needs service. When I use my POST card I get the following code "b5" along with the 11.01 error that shows on the screen. I cannot find any info on it. The BIOS version is AST 2.02.

Thanks,
Matt
dani9678
Initiate
Initiate
 
Posts: 62
Joined: Fri Mar 23, 2012 8:39 pm

Re: Issue with AST Premmia MX P/60 giving 11.01 message at p

Postby Karlsweldt » Mon Dec 11, 2017 9:49 am

"AST P60".. that is a veteran! The error code could refer to several problems, such as memory not seated properly or wrong type, device card not properly seated, to the hard drive not spinning up fast enough to meet the BIOS self-ID time. Even if the CPU was not compliant to the board design. Ensure all devices, memory and CPU are properly seated, the PSU voltages are on target. More than 2% off the mark, and PSU voltages can cause problems.
F@H.. to solve mankind's maladies.. in our lifetimes!
Karlsweldt
Mobo-fu Master
Mobo-fu Master
 
Posts: 20836
Joined: Wed Nov 12, 2003 11:57 am
Location: 07438

Re: Issue with AST Premmia MX P/60 giving 11.01 message at p

Postby evasive » Fri Feb 23, 2018 7:44 am

From another post in another forum:
I reinstalled the CMOS battery after charging it and when I powered it on it loaded fine.


So no error codes then? It means you need to replace the CMOS battery I guess.
We hate rut, but we fear change.
********************************
System error, strike any user to continue...
evasive
Mobo-fu Master
Mobo-fu Master
 
Posts: 37454
Joined: Sun May 06, 2001 12:01 am
Location: Netherlands


Return to BIOS

Who is online

Users browsing this forum: No registered users and 3 guests