tx pro 2 motherboard

All hardware or software issues that do not have a specific forum go here.

Moderator: The Mod Squad

tx pro 2 motherboard

Postby poster1 » Sat May 11, 2013 6:48 am

Hi, I am trying to find out whether the Mitac SPU-75 psu i have, is compatible with tx pro 2 mother board, as when I plug it in, only the mthrbrd /cpu and the disks power on and I don't hear a POST signal?

Would be relieved if anyone could help.

Thanks a lot
poster1
Pilgrim
Pilgrim
 
Posts: 3
Joined: Sat May 11, 2013 6:14 am

Postby Karlsweldt » Sat May 11, 2013 7:04 am

Welcome to Motherboards.org.
That power supply is way too inadequate for that motherboard! It is rated at only 75 watts, and you would need a minimal 350 watt PSU to power it.
Motherboard specs:
Better to use a 400 watt PSU, it will not "push" more power to the system than required. But the unused wattage is a good factor for proper regulation.
F@H.. to solve mankind's maladies.. in our lifetimes!
Karlsweldt
Mobo-fu Master
Mobo-fu Master
 
Posts: 20659
Joined: Wed Nov 12, 2003 11:57 am
Location: 07438

Postby evasive » Sun May 12, 2013 8:54 am

Baby AT power supply, Baby AT board, with this chipset has to be the PC Chips M571

http://m571.com/m571/

Please check the troubleshooting sticky post in the tech support forum.

For this setup if you're not using a supserduper gaming card a 200 or 235 W AT supply will be fine. Make sure the memory you're using is compatible and the jumper settings for the CPU match.
We hate rut, but we fear change.
********************************
System error, strike any user to continue...
evasive
Mobo-fu Master
Mobo-fu Master
 
Posts: 37389
Joined: Sun May 06, 2001 12:01 am
Location: Netherlands


Return to General

Who is online

Users browsing this forum: No registered users and 2 guests